Magigoo - Flex Pen 50ml - Adhesion for Flexible Filaments

by Magigoo
Save 75%
£19.99 (Inc VAT)
£4.99 (Inc VAT)


MAGIGOO Flex was developed for professional use and can only be used with TPU (thermoplastic polyurethane), TPE (thermoplastic elastomer and TPC (thermoplastic copolyester) filaments.


Some flexible filaments show less adhesion to conventional 3D printing surfaces and a high tendency to warp. Others cling too well to bare 3D printing surfaces such as glass and PEI. MAGIGOO Flex is a specialized solution for FDM flexible filament printing developed for a wide variety of flexible filament types. MAGIGOO Flex acts as an intermediate layer between the building board and the printed part, enabling good adhesion.


MAGIGOO Flex was developed and tested for use with various flexible filament brands.

  • Shake the bottle.
  • Apply to the desired area by pressing the spring on the bed (activate the inner valve).
  • Print according to the recommendations of the filament / printer manufacturer
  • Allow to cool and remove. The imprint should be visible immediately
  • Cleaning - Use a damp cloth to wipe.

Additional Information:

Using this product with filaments other than flexible filaments may cause over-adhesion and damage your surface.

For larger prints and filaments with a high shrink rate, a margin of 20 mm is recommended. In case of excessive adhesion, it is recommended to wet the print bed with a little water and to work it below the part. This should make it easier to remove the part.

Technical Data Sheet